How to change a hayward led pool light? (2023)

How do you change an LED pool light?

How To: Replace a Pool Light Fixture - YouTube

How long does the light last? The life expectancy for a Colorlogic light is 50,000 hours. The light will perform for over 10,000 hours without any noticeable loss of brightness.

Twist the trim ring clockwise until it firmly locks. The Hayward logo should now be in the 12 o'clock position (Figure 3). To remove the Universal ColorLogic/CrystaLogic LED Light from the LFGUY1000 Niche: Remove the trim ring by turning it counter clockwise.

How To: Replace A Swimming Pool or Spa Light Bulb - YouTube

Replacing pool lights for your in-ground swimming pool does not require draining the water from the pool or hiring a professional. The design of the pool light's housing allows you to remove it from the pool without the need to disconnect any wiring.

ColorLogic® 120V LED Replacement Bulbs are a quick, cost-effective way to upgrade standard incandescent pool lights to vibrant, color-rich, energy-efficient LEDs. Installation does not require rewiring or fixture replacements.

Check the lighting fixtures

You might be dealing with a worn-out seal, and you may need to have it replaced. If the lighting itself is the problem, you may need to buy new LED lights, especially if it's been damaged. If you're dealing with a blown bulb, you'll also need to get that replaced.

It costs a lot of money to have sales people to go to all the different pool store chains that must be covered in the bulb price. You aren't paying for a better bulb, you are paying for expensive overhead and multiple mouths to feed when each bulb is sold.

How to fault test a pool light fixture - YouTube

How often do pool lights need to be replaced?

Most incandescent bulbs will burn for 1,000 hours before bulb replacement is necessary. LED bulbs can burn for 25 years or more (or so they tell us).

The homeowner can install the pool niche into the cutout for the pool light. Follow the Hayward pool light niche installation instructions. When mounting the light niche, push it through the wall from the inside out and then once in place you tighten the lock ring on the back of the niche to seal it against the wall.

If your pool light bulb is flickering or turned off and the housing is still dry, it may be that the bulb just needs replacing. Be careful, though, because if the bulb isn't lasting as long as it should that is an indicator of a much worse problem such as a power surge or some faulty wiring somewhere.

If you have a Hayward pool light, you can use the Hayward ColorLogic LED pool light. lamp will fit pool light niches by American, Anthony, Hayward, Pac-Fab, Paragon, Pentair, Purex, Sta-Rite and Swimquip. It's universal because it will fit into most any other pool light niche.

Check the lighting fixtures

You might be dealing with a worn-out seal, and you may need to have it replaced. If the lighting itself is the problem, you may need to buy new LED lights, especially if it's been damaged. If you're dealing with a blown bulb, you'll also need to get that replaced.

LED lights are renowned for their durability lasting for well over 20,000 hours. Quality LED brand names can last for 10 years or more. This will reduce for those lower cost products.

How much do inground pool lights cost? At the time of this writing, full size LED pool lights, like what are typically installed in vinyl liner or concrete pools, usually cost between $1,000 and $1,500 installed.

Jandy Swimming Pool Light Installation - YouTube